Skanyx
DTC/P0219·Honda

P0219 on Honda: Causes, Symptoms and Fix Cost

Quick Answer
High SeveritySafe to drive (short-term)Honda

P0219 on a Honda means the engine RPM exceeded the manufacturer's maximum safe limit, known as the redline. This typically happens from an accidental or aggressive downshift, a transmission control fault, or a stuck throttle. The ECU logs this code to flag a potential engine damage event from over-revving.

Repair cost on Honda17 - €638

What does P0219 mean on a Honda?

P0219 means the engine RPM exceeded the manufacturer's maximum safe limit, known as the redline. This typically happens from an accidental or aggressive downshift, a transmission control fault, or a stuck throttle. The ECU logs this code to flag a potential engine damage event from over-revving.

Honda Civic

2006-2024

P0219 on Honda Civic is almost always driver-caused: an accidental downshift (from 4th to 2nd instead of 3rd, for example) on manual transmission models, especially Si and Type R variants where the 8,000+ RPM redline is reached more easily. The K-series engines have built-in over-rev protection that triggers this code on rotation events above the limiter. No mechanical fault is usually present; the code can typically be cleared after one over-rev event.

What causes P0219 on a Honda?

Beyond the generic causes listed on the main P0219 page, these are the Honda-specific patterns we see most often:

Honda CivicDriver accidental downshift on manual transmission (Civic Si, Type R) causing over-rev event
Honda CivicWorn synchros on high-mileage manual transmissions producing rev hang during shifts

How to diagnose P0219 on a Honda with OBD2

Follow these steps to pinpoint the root cause of P0219:

  1. Retrieve freeze frame data with a scan tool to determine the conditions when the code was set - check engine RPM, vehicle speed, gear position, and throttle position at the time of the event
  2. Ask the driver about the circumstances. If the code was set during an intentional or accidental aggressive downshift, the code may be informational only. Clear it and monitor
  3. If the code recurs during normal driving, check the crankshaft position sensor signal for erratic readings that could cause a false overspeed detection
  4. Inspect the transmission for fault codes. On automatic transmissions, check for TCM faults that could cause unexpected downshifts at high speed
  5. Check the throttle body and accelerator pedal position sensor for erratic signals that could cause unintended wide-open throttle

How much does P0219 cost to fix on a Honda? (EUR)

Estimated repair costs on a Honda (Honda parts and labour typically run 15% below the average for this code).

Repair Parts Cost Labor Cost Total Estimate DIY Difficulty
Clear code and monitor (if caused by driver error) €0–€0 €17–€51 €17–€51 Easy
Replace crankshaft position sensor €17–€68 €34–€102 €51–€170 Moderate
Transmission control module diagnosis and repair €85–€425 €68–€213 €153–€638 Professional
Throttle body or pedal sensor replacement €43–€213 €34–€102 €77–€315 Moderate

Prices estimated as of May 2026. Costs vary by region, vehicle, and shop.

These codes commonly cluster with P0219 on Honda vehicles:

FAQ: P0219 on Honda

What does P0219 engine overspeed mean?

P0219 means the engine RPM exceeded the maximum safe limit set by the manufacturer (typically 6,500-7,500 RPM depending on the engine). The ECU logs this as a warning. It can happen from a missed downshift, a transmission fault, or a throttle control issue.

Can a downshift cause P0219?

Yes, this is the most common cause. Downshifting a manual gearbox or using paddle shifters at too high a speed forces the engine past its redline. Most modern cars have rev-matching or downshift protection, but it can still occur in certain conditions.

Does P0219 mean my engine is damaged?

Not necessarily. A brief overspeed event usually causes no damage as the ECU cuts fuel to protect the engine. However, repeated or severe over-revving can damage valves, valve springs, or the connecting rods. If the engine sounds different after the event, have it inspected.

Can I clear P0219 myself?

Yes. If the overspeed was caused by a one-time driver error (like a missed downshift), you can clear the code with an OBD2 scanner and monitor. If it returns during normal driving, there may be a sensor or transmission control fault that needs diagnosis.

Looking for the full P0219 reference (all makes, full diagnosis flow, complete repair cost matrix)?

See the main P0219 guide
Skanyx · Honda

Diagnosing P0219 on your Honda?

Connect any Bluetooth OBD2 adapter, scan for codes, and get AI-powered diagnostics with severity ratings and repair cost estimates.

Download Skanyx