P0520 means the ECU sees an out-of-range or implausible signal on the oil pressure sensor circuit. Usually a failed sensor or wiring fault, but it can also flag genuinely low oil pressure, which is why you can't just clear it and drive.
P0520 on Chevrolet: Causes, Symptoms and Fix Cost
P0520 on a Chevrolet means the ECU sees an out-of-range or implausible signal on the oil pressure sensor circuit. Usually a failed sensor or wiring fault, but it can also flag genuinely low oil pressure, which is why you can't just clear it and drive.
What does P0520 mean on a Chevrolet?
Chevrolet Silverado 1500
2007-20135.3L V8 (LC9/LMG) sensor sits under the intake manifold at the rear of the valley. Covered by GM TSB PIP4653 and a well-known AFM-related failure pattern. Intake removal is required.
What causes P0520 on a Chevrolet?
Beyond the generic causes listed on the main P0520 page, these are the Chevrolet-specific patterns we see most often:
How to diagnose P0520 on a Chevrolet with OBD2
Follow these steps to pinpoint the root cause of P0520:
- Check oil level on the dipstick (or via the electronic gauge on BMW/Audi) before anything else. If it's low, top up and inspect for leaks.
- Connect a mechanical oil pressure gauge at the sensor port. Compare idle and 2500 rpm readings to the service manual spec (typically 25-30 psi hot idle, 55-65 psi at 2500 rpm on most engines).
- If real pressure is in spec, unplug the sensor connector and inspect for oil intrusion, green corrosion, or spread pins.
- Key on, engine off: back-probe the connector. Confirm 5V reference (variable sensors) or battery voltage (switches), a clean ground, and continuity on the signal wire back to the PCM.
- Substitute a known-good sensor, clear the code, and retest under the conditions that set it.
- If the code returns with a good sensor and clean wiring, scope the signal for dropouts during a road test.
- If actual pressure is low, drop the pan and inspect the pickup screen for sludge before condemning the pump.
How much does P0520 cost to fix on a Chevrolet? (EUR)
Estimated repair costs on a Chevrolet (Chevrolet parts and labour typically run 40% above the average for this code).
Prices estimated as of May 2026. Costs vary by region, vehicle, and shop.
Related codes that often appear with P0520 on Chevrolet
These codes commonly cluster with P0520 on Chevrolet vehicles:
FAQ: P0520 on Chevrolet
Can I just clear P0520 and keep driving?
Only after you've confirmed real oil pressure with a mechanical gauge. Clear it while pressure is actually low and you're rolling the dice on rod bearings.
Why did P0520 come on right after an oil change?
Three usual suspects: wrong viscosity (5W-30 in a spec 0W-20 engine reads odd at cold start), a defective filter with a stuck bypass, or the sensor connector got bumped loose. Recheck the connector first, it's free.
Is a leaking oil pressure sensor the same fault?
Usually yes. The GM 5.3L LC9 sensor is famous for cracking and weeping oil into the connector, which then shorts the signal wire. If yours is wet, replace it whether it's throwing the code yet or not.
How long does the sensor itself take to replace?
15 minutes on a Ford 5.4L switch. Two to three hours on a GM LS truck engine because the intake manifold has to come off. Budget accordingly.
Can a weak battery or bad ground trigger P0520?
Yes. Sub-11V cranking voltage and corroded engine-to-body grounds cause implausible sensor readings across the board. Load-test the battery and clean the grounds before chasing wires.
Looking for the full P0520 reference (all makes, full diagnosis flow, complete repair cost matrix)?
See the main P0520 guideDiagnosing P0520 on your Chevrolet?
Your car logged {code}. Skanyx reads it on any standard Bluetooth OBD2 adapter, tells you whether it is safe to keep driving, and shows the {costRange} repair range so you know the number before a shop quotes you.
Download Skanyx