The Quick Answer above is the generic definition. What follows is what is documented for the Audi models that log P0671, checked against manufacturer data and owner reports.
DTC/P0671·Audi
P0671 on Audi: Causes, Symptoms and Fix Cost
Quick Answer
Moderate SeveritySafe to drive (short-term)Audi
P0671 on a Audi is a diesel-only code meaning the engine control unit detected an electrical fault in the glow plug circuit for cylinder 1. Glow plugs preheat each combustion chamber so a cold diesel can ignite. The code identifies the cylinder 1 circuit specifically, usually pointing to a failed plug, its wiring, or its connection rather than the whole system. Repairs typically run 30-180 EUR for a single plug and circuit fix.
Repair cost on Audi€5 - €420
Connect any standard Bluetooth OBD2 adapter to your Audi and Skanyx tells you what P0671 means on that engine, whether it is safe to keep driving, and what the fix should cost. Free on iPhone and Android.
Get Skanyx freeWhat does P0671 mean on a Audi?
Audi A4 TDI
2004-2019The A4 TDI uses the same VAG per-plug monitoring as the Golf, so P0671 isolates cylinder 1. Some 2.0 and 3.0 TDI engines use fragile ceramic glow plugs that can snap if removed cold, so warm removal is essential. Replacing one plug is inexpensive unless a ceramic plug breaks off in the head.
What causes P0671 on a Audi?
Beyond the generic causes listed on the main P0671 page, these are the documented Audi-specific patterns:
Audi A4 TDIFailed cylinder 1 plug on VAG TDI engines
Audi A4 TDIFragile ceramic plug snapping on some 2.0/3.0 TDI
How to diagnose P0671 on a Audi with OBD2
Follow these steps to pinpoint the root cause of P0671:
- Read the stored code and freeze frame with Skanyx or any ELM327 adapter to confirm P0671 and note the start temperature when it set
- Locate the cylinder 1 glow plug and inspect its connector and wiring for corrosion, looseness, or damage
- Disconnect the cylinder 1 glow plug and bench-test it with a multimeter: a healthy plug reads roughly 0.5-2 ohm, while an open (infinite) reading confirms that plug has failed
- If the cylinder 1 plug is good, check continuity of its wiring back to the control module and verify a clean ground
- Remember that per-cylinder glow plug live status is manufacturer-extended (Mode $22) data, not generic OBD2, so the multimeter test on the cylinder 1 plug is how you confirm the failure
- Consider replacing the full set if the plugs are original and high-mileage, since the others are likely to fail soon
How much does P0671 cost to fix on a Audi? (EUR)
Estimated repair costs for P0671 in EUR, compiled across makes. Expect Audi parts and labour towards the upper end of each range.
Prices estimated as of March 2026. Costs vary by region, vehicle, and shop.
Related codes that often appear with P0671 on Audi
These codes commonly cluster with P0671 on Audi vehicles:
Looking for the full P0671 reference (all makes, full diagnosis flow, complete repair cost matrix)?
See the main P0671 guideSkanyx · Audi
Diagnose P0671 on your Audi
Your car logged P0671. Skanyx reads it on any standard Bluetooth OBD2 adapter, tells you whether it is safe to keep driving, and shows the €5-€420 repair range so you know the number before a shop quotes you. Free on iPhone and Android, and you do not need to be a mechanic to read it.
Get Skanyx free