Skanyx
DTC/P0135·Honda

P0135 on Honda: Causes, Symptoms and Fix Cost

Quick Answer
Low SeveritySafe to drive (short-term)Honda

P0135 on a Honda means the heater circuit in your Bank 1 upstream (pre-catalyst) oxygen sensor has failed. Unlike P0141 (downstream sensor), this sensor directly controls the air-fuel mixture, so heater failure causes noticeably worse fuel economy and higher emissions during cold starts until exhaust heat warms the sensor naturally.

Repair cost on Honda1 - €360

What does P0135 mean on a Honda?

P0135 means the heater circuit in your Bank 1 upstream (pre-catalyst) oxygen sensor has failed. Unlike P0141 (downstream sensor), this sensor directly controls the air-fuel mixture, so heater failure causes noticeably worse fuel economy and higher emissions during cold starts until exhaust heat warms the sensor naturally.

Honda Civic

2006-2024

The upstream sensor on the Civic R18A is accessible from the top of the engine. On the 1.5T, the sensor is closer to the turbo manifold where temperatures are extreme, leading to faster heater degradation. NTK/NGK sensors are Honda OEM.

What causes P0135 on a Honda?

Beyond the generic causes listed on the main P0135 page, these are the Honda-specific patterns we see most often:

Honda CivicAccelerated heater wear near turbo manifold on 1.5T
Honda CivicStandard degradation on R18A at 80,000-120,000 km

How to diagnose P0135 on a Honda with OBD2

Follow these steps to pinpoint the root cause of P0135:

  1. Check for multiple heater codes (P0141, P0155, P0161). Multiple codes suggest a shared fuse or wiring issue
  2. Check the O2 sensor heater fuse in the fuse box. Replace if blown
  3. Unplug Bank 1 Sensor 1 connector and measure heater resistance. Healthy: 2-15 ohms. Open circuit: burned out. Under 1 ohm: short
  4. Inspect connector for corrosion, bent pins, or water intrusion
  5. Check wiring for chafing against exhaust manifold or heat shields

How much does P0135 cost to fix on a Honda? (EUR)

Estimated repair costs on a Honda (Honda parts and labour typically run 10% below the average for this code).

Repair Parts Cost Labor Cost Total Estimate DIY Difficulty
Replace O2 sensor heater fuse €1–€3 €0–€0 €1–€3 Easy
Replace upstream O2 sensor (Bank 1) €45–€162 €45–€108 €90–€270 Moderate
Repair wiring or connector €5–€18 €36–€108 €41–€126 Moderate
Replace O2 sensor (OEM quality) €72–€252 €45–€108 €117–€360 Moderate

Prices estimated as of May 2026. Costs vary by region, vehicle, and shop.

These codes commonly cluster with P0135 on Honda vehicles:

FAQ: P0135 on Honda

Is P0135 worse than P0141?

Yes, slightly. P0135 is the upstream sensor that controls fuel mixture. P0141 is downstream and only monitors converter efficiency. A failed P0135 heater means worse fuel economy and richer running during cold starts.

Can I drive with P0135?

Yes, safely. But fuel economy is noticeably worse on short trips where the sensor never warms up naturally. Fix it promptly.

Can a blown fuse cause P0135?

Yes. O2 sensor heaters share a fuse. If it blows, you'll see multiple heater codes at once. Check the fuse before buying a sensor.

What is the difference between P0135 and P0141?

P0135 is Bank 1 Sensor 1 (upstream, pre-catalyst). P0141 is Bank 1 Sensor 2 (downstream, post-catalyst). Same heater failure, different sensor position and impact.

Looking for the full P0135 reference (all makes, full diagnosis flow, complete repair cost matrix)?

See the main P0135 guide
Skanyx · Honda

Diagnosing P0135 on your Honda?

Connect any Bluetooth OBD2 adapter, scan for codes, and get AI-powered diagnostics with severity ratings and repair cost estimates.

Download Skanyx