Skip to content
Skanyx

P1290 on Jaguar: Causes, Symptoms and Fix Cost

Quick Answer

Safe to drive (short-term)

P1290 on a Jaguar is a manufacturer-specific code, so its meaning depends on the make. Ford, and Jaguar on its V6 S-Type, list it as a cylinder head temperature (CHT) sensor circuit low input: the computer sees a voltage below the expected range, which it reads as a very hot engine. Volkswagen lists it as engine coolant temperature sensor input too high, and other makes use the number for unrelated faults. Confirm the definition for your car before replacing parts.

Severity
Moderate · Cooling System
Typical repair cost, all makes
€10-€1800

Connect a standard OBD2 adapter (Bluetooth LE on iPhone) to your Jaguar and Skanyx tells you what P1290 means on that engine, whether it is safe to keep driving, and what the fix should cost. Free on iPhone and Android.

Get Skanyx free

What does P1290 mean on a Jaguar?

The Quick Answer above is the generic definition. What follows is the model-specific detail for the Jaguar models that log P1290.

Jaguar S-Type V6

2000-2002

A Jaguar S-Type fault-code reference for the 2000 to 2002 model years (hosted by the Jaguar Clubs of North America) lists P1290 on the V6 as CHT sensor sense circuit low voltage (high temperature), with P1289 as the high-voltage twin. Its listed causes are an engine overheat condition (checked first via the overheat code), a short to ground in the CHT sensor wiring and a failed sensor. The computer falls back to a fixed default temperature of 102 °C while the fault is present.

Source: host.jcna.com

Sources

  1. host.jcna.com host.jcna.com/sites/default/files/STYPE.pdf

What causes P1290 on a Jaguar?

Beyond the generic causes listed on the main P1290 page, these are the patterns noted for Jaguar models:

  • Engine overheat condition

    : Jaguar S-Type V6

  • Short to ground in the CHT sensor wiring

    : Jaguar S-Type V6

  • CHT sensor failure

    : Jaguar S-Type V6

How to diagnose P1290 on a Jaguar with OBD2

  1. Confirm which definition applies. On a Ford or a V6 Jaguar it is a CHT sensor circuit fault, on a Volkswagen a coolant temperature sensor signal that is too high
  2. Read all codes and the freeze frame, and note any other temperature sensor codes stored with P1290
  3. Compare the temperature reading on a scan tool with the real engine temperature. A cold engine should read close to the outside temperature, and a warm one should climb steadily to normal
  4. Check the coolant level and look for leaks or air in the system, since a false reading can follow a low level
  5. Inspect the sensor plug and wiring for corrosion, chafing and loose pins, and wiggle the harness with the engine running to see whether the reading jumps
  6. If your reader shows a stuck or impossible value, measure the sensor's resistance and compare it with the manual. A CHT sensor is a two-wire thermistor, so its resistance changes with temperature
  7. Replace the sensor only after the wiring is proven good, then clear the code and road test

How much does P1290 cost to fix on a Jaguar? (EUR)

Estimated repair costs for P1290 in EUR, compiled across makes. Expect Jaguar parts and labour towards the upper end of each range.

Repair Parts Cost Labor Cost Total Estimate DIY Difficulty
Replace cylinder head or coolant temperature sensor €12–€60 €40–€100 €52–€160 Easy
Repair shorted or open wiring or replace the connector €5–€40 €60–€160 €65–€200 Moderate
Diagnose the circuit with a meter (shop) €0–€0 €60–€120 €60–€120 Professional
Top up coolant and bleed the cooling system €10–€30 €0–€60 €10–€90 Easy
Engine computer repair or replacement (rare) €400–€1500 €100–€300 €500–€1800 Professional

Prices estimated as of October 2026. Costs vary by region, vehicle, and shop.

These codes are often seen alongside P1290 or point to related issues, on any make:

Looking for the full P1290 reference (all makes, full diagnosis flow, complete repair cost matrix)? See the main P1290 guide

Diagnose P1290 on your Jaguar

Get Skanyx free