P0014 on Honda: Causes, Symptoms and Fix Cost

The Quick Answer above is the generic definition. What follows is the model-specific detail for the Honda models that log P0014.

Beyond the generic causes listed on the main P0014 page, these are the patterns noted for Honda models:

Follow these steps to pinpoint the root cause of P0014:

1. Check the engine oil first. Pull the dipstick and confirm the level is correct and the oil is clean, not black and gritty. Variable valve timing runs entirely on oil pressure, so low or sludged oil is the single most common cause of P0014. If the oil is overdue or the wrong grade, change it and the filter before doing anything else, then clear the code
2. Scan for related codes. P0014 often appears alongside P0010, P0011, P0013, P0021, or P0024. Reading the full set tells you whether the problem is on one cam, one bank, or affecting the whole timing system, which narrows down whether you are chasing a solenoid or a chain
3. Inspect and test the camshaft oil control valve (VVT solenoid). Unplug it, check the connector and wiring for damage, then remove it and look at the screen filter and plunger. A solenoid caked with sludge is a frequent cause. Clean it with brake cleaner or replace it, refit, and clear the code
4. Command the variable valve timing actuator with a bidirectional scan tool. Watch the actual cam timing follow the commanded value. If the cam overshoots or will not hold position with a known-good solenoid and clean oil, the cam phaser itself is worn
5. Inspect the cam phaser and timing chain. Listen for a startup rattle and check chain stretch against the manufacturer spec. A stretched chain shifts cam timing and can set P0014 even when the solenoid and phaser are fine. This is the last and most expensive item to confirm

Estimated repair costs for P0014 in EUR, compiled across makes. Honda costs typically sit in the middle of each range.

These codes are often seen alongside P0014 or point to related issues, on any make: