P0110 on Toyota: Causes, Symptoms and Fix Cost

The Quick Answer above is the generic definition. What follows is the model-specific detail for the Toyota models that log P0110.

Beyond the generic causes listed on the main P0110 page, these are the patterns noted for Toyota models:

Follow these steps to pinpoint the root cause of P0110:

1. Read every stored code and the freeze frame. A generic OBD2 reader can do this and can show live intake air temperature, which is enough for most of the tests below. It cannot show a manufacturer's internal sensor error detail or run the manufacturer's own test routine, which needs manufacturer-level software. If several sensors report faults at once, suspect a shared sensor ground before any single sensor
2. With the engine cold and the ignition on, read the live intake air temperature. It should be close to the outside temperature. A reading of -40 degrees C means the ECU sees an open circuit; an impossibly high reading (Toyota uses 140 degrees C) means a short. A plausible reading that jumps while you wiggle the connector and harness is an intermittent contact
3. Find the sensor. It is either a separate sensor in the intake duct or air filter housing, or built into the mass air flow sensor. Check that the plug is fully home and locked, and look for corroded, pushed-back or bent pins, especially if the air filter was changed recently
4. On an analogue sensor (a separate one, or one built into an older air flow meter as on the second-generation Prius), test the wiring from the plug. With the sensor unplugged and the ignition on, the reading should fall to -40 degrees C. Then bridge the signal and ground pins on the harness side: the reading should jump to the hottest value. If both happen, the wiring and ECU are fine and the sensor is at fault. If the reading stays at -40 with the bridge fitted, a wire is open; if it stays hot with the sensor unplugged, the signal wire is shorted to ground
5. On a separate analogue sensor, measure its resistance. It is a thermistor whose resistance falls as it warms, typically around 2,000 to 3,000 ohms at 20 degrees C; an infinite reading means an open element. Compare with the figure in the manual for your engine
6. On engines where the MAF and IAT form one digital sensor, the sensor reports its own internal errors and cannot be checked with an ohmmeter. Follow the manufacturer's procedure, which checks fitting, connector and wiring before condemning the sensor
7. After the repair, clear the code, restart, and confirm the live temperature reads close to ambient and rises steadily as the engine bay warms up

Estimated repair costs for P0110 in EUR, compiled across makes. Expect Toyota parts and labour towards the upper end of each range.

These codes are often seen alongside P0110 or point to related issues, on any make: